To set the IP address statically, for e.g. as 192.168.56.20, change the above entry to look as: auto enp0s3 iface enp0s3 inet static address 192.168.56.20 netmask 255.255.255.0 gateway 192.168.40.31. The entries above are self-explanatory for moderate Linux users. To apply the changes, you need to run the command: To use this IP changer to hide your real IP address, you only need to download the iTop VPN free to use and install it on your computer. Then double click & execute the program, the main interface will show off like below. The software will inform you that “You are exposed”. Setting a static IP address. Enter the desired IP address in the IP address field (A). Then press the "tab" button to auto-populate the subnet mask field (B). The defaut gateway field (C) does not necessarily need to be set. Most direct connections will not require this field. Do not set the PC to the same IP address as the device. Pia S5 Proxy is the world's largest commercial residential proxy service. With over 350 million fresh residential IPs that can be located by country, city, postcode, and ISP, it supports both HTTP(S) proxy and Socks5 proxy, allowing you to easily access the Internet and protect your privacy while increasing network security. A right-click on the icon can then be used to set an IP address for the selected network adapter. IP Switcher is a handy tool for users who have to work in different network environments that force them to change IP related settings regularly. The 65K program can be downloaded from the developer's website. It is compatible with both 32-bit and 1] Setting a static IP address via Control Panel. Right-click the network (or Wi-Fi) icon visible on Windows 10 Taskbar. From the list of 2 options displayed, select the latter one – Open Begin by opening the Command Prompt by typing “command” on the search bar. Then right-click over the command prompt and left-click on “Run as Administrator”. You’ll do this to make any change to your IP address using the command prompt (more on that later). Type in the command “ipconfig” and press enter on your keyboard. There are following steps involved to configure an IP Address to PC: Step1: Open the Cisco Packet Tracer. Step2: Drag and drop PC from the bottom of the interface into the middle of the working area. Step3: Click on PC ->Config Gateway like 10.0.0.1 Click on FastEthernet to assign an IP address and subnetmask to the PC, and close PC window. 1A39.